On this page
REFERENCE
Troubleshooting
Start with the visible message, then check one connection or condition at a time.
First open SYSTEM and note the logger state, CAN, GPS, SD, clock and IP. These checks usually identify where to start.
PC cannot connect over USB
- Select PC in SYSTEM → USB MODE and restart. Check the running USB status.
- Use a known data-capable cable and try another PC port. Select the correct COM port in SXTune.
- The USB connection uses a COM port. Use a card reader if you want to copy files directly from the SD card.
- An absent SD card should not stop logger identification . If identification still fails, note the firmware version and exact PC error.
CAN WAITING, BUS OFF or missing tile values
Check ECU power, the supplied CAN wiring, termination and matching baud rate. ACTIVE confirms recent frames, not the availability of every channel. For dashes on a built-in tile, choose a known broadcast signal and check ECU export settings. For a static tile, confirm it is logged at a non-zero rate, send the configuration and allow for the first reply; it becomes stale after five seconds without one.
Logger will not record / stops early
| Check | Action |
|---|---|
| NOT CONFIGURED / no channels | Connect SXTune and send a valid logger configuration; verify the channel count. |
| CONFIGURED, waiting | Check the automatic trigger. Try START LOGGER to separate a trigger issue from a recording issue. |
| START/STOP tap ignored | Tap the lower half of the button and watch for the state change. |
| SD NO CARD / ERROR | Stop, power off and reseat the card; try a known-good approved FAT32 card. |
| DTT/DTD create or write error | Check free space, card readability and a test card. Preserve existing logs before formatting. |
| BUFFER OVERRUN | Recording is not keeping up. Save the configuration and exact error, test with a known-good card and fewer/lower-rate channels; have persistent cases investigated. |
| Unexpected automatic start/stop | Check the trigger channel and settings in SXTune. Make a short test recording and confirm the automatic start and stop conditions. |
Dash missing from Wi-Fi / transfer fails
Stop logging. Check WIFI shows a connection or access point and an IP. Put the PC on the same local network; avoid guest/client isolation. Try the Dash access point directly and stay connected despite the no-internet warning. Retry the affected recording and verify both files. Use USB or a card reader if needed.
DOWNLOADING FILES with a frozen normal dashboard is expected during transfer. If it remains after the PC reports an error, check/re-establish the connection and the resulting files before retrying.
No GPS fix or predictive delta
Check GPS mode and restart, or connect the receiver before boot in Automatic. Distinguish no receiver, no data and no fix. Move into clear sky and wait. Then confirm the circuit layout and timing line and complete a full valid lap. A layout change or discarded lap needs a new reference.
Screen stays on / GPS missing after wake
Check CAN activity, PC USB and downloads first: they can keep the Dash awake. Look for STANDBY ERROR - REBOOT, note the stage/code and power-cycle after stopping any recording. Report persistent recovery issues to your SCS Delta dealer. See sleep and wake instructions.
TIME NOT SET, unexpected reset or damaged last log
Check/set the logger clock through the PC software before the next session. Record any LAST RESET text, particularly BROWNOUT / LOW VOLTAGE. Check the vehicle power supply and connections. Back up an important SD card before another boot or recovery attempt; the latest log may be repaired and empty pairs cleaned up. See power-loss recovery limits.
What to include in a fault report
Note the Dash firmware version if known, PC software version, exact screen message, USB mode, CAN state, SD state/free space, GPS connection/fix and Wi-Fi IP. Describe what you did immediately before the fault and whether a restart changes it. Preserve a copy of the logger configuration and affected DTT/DTD pair where relevant.
