On this page

RECORDING

SD card & file care

Check storage readiness, copy log pairs safely and understand recovery limits.

Recording needs a working FAT32 microSD card. Check SD READY and available space before each session.

Use the supplied or approved FAT32 microSD card.

Fit and check the card

  1. Stop recording and downloads. Switch off the Dash before inserting or removing the microSD card.
  2. Insert the card securely, power on and open SYSTEM.
  3. Check SD READY and used/total space. Make a short test log if the card is new or has been reformatted.
  4. If you need to format a card on a PC, back up its contents first and use FAT32. Formatting erases the card.
SD statusMeaning / action
READYThe card is mounted. Check available space and verify a test recording.
NO CARDNo usable card is detected. Power off, check seating and try again.
ERRORA card is detected but is not ready. Back it up on a PC if readable; check the format and try a known-good FAT32 card.

Where recordings live

The Dash stores DTT/DTD recording pairs in the card’s root directory. Copy both matching files to the same folder on the PC. An SD card is not required just for SXTune to identify the Dash, but it is required for recording and reading saved files.

Always stop recording, power off and then remove the card. Do not pull it out during a write or transfer.

After unexpected power loss

When a card is first read after startup, the Dash attempts to recover the most recent DTT/DTD pair using complete data blocks that reached the card. It also removes log pairs where either half is zero length.

Recovery cannot recreate buffered samples that were never written. The final incomplete second can be lost, and the recovered final lap may end at the last complete block. A consistent pair is left unchanged.

Card care

Keep a backup of completed sessions and leave enough free space for the next run. If write errors repeat, try a known-good approved card before changing the logging setup. Do not rely on recovery as the normal way to finish a recording: use STOP LOGGER and wait.

Screen reference